Braeburn 5400 User Manual download pdf (Page 6)

10 11

Entering Your Program–7 DAY, Residential Mode (continued)

Individual Days –

allows you to program each day of the week individually to give you the greatest schedule

ﬂexibility. Often used to ﬁne tune programming after initial programming.

IMPORTANT NOTE! When in Whole Week programming, the thermostat will check if all of the days of that

group have the same program set point times and temperatures. If so, the set point time and temperature of the

individual set point will be displayed.

Otherwise, the individual set point time and temperature will be blanked. The user is allowed to change the daily

programs for this set point time and temperature by pressing the or button. This will reset all the daily

programs of the group for that speciﬁc individual set point time and temperature to the startup default for that

set point. Continued pressing of the or button by the user will change set point time and temperature

settings as desired.

Programming Instructions–7 DAY, Residential Mode

1. Press the PROG button to enter the Program setting mode.

Press the SYSTEM button to select HEAT (not AUTO HEAT) to set

heating times and temperatures. MORN set point of the “Whole

Week” will be displayed. The display will show M, TU, W, TH,

F, SA, SU to indicate the whole week is being programmed.

The hour portion of the set point time and the AM/PM indicator

will be ﬂashing.

PROGRAMMING

USER SETTINGS

cont.

PROGRAMMING

USER SETTINGS

cont.

2.5 Setting Your Energy Saving Programs (continued)

• Independent heating and cooling temperatures are available in auto changeover mode. Independent program times and

fan settings for heating and cooling are NOT available in auto changeover mode.

• When you place the system in the HEAT or COOL modes of operation, an appropriate indicator will appear in the LCD

display when the system is running.

• When you place the system in the OFF mode the display will indicate OFF.

NOTE: If the PROG button is pressed while AUTO is selected, the

thermostat will switch from the AUTO mode to the mode currently in

the display.

NOTE: If Auto Changeover is enabled in the Installer Options, and a

setting is made in either heating or cooling which violates how far apart

heat and cool are (the dead band), the opposite mode will adjust up or

down automatically to maintain the dead band spacing (see section 3.2).

NOTE: If a Heat Limit was set in the Installer Options, the heating set

point cannot exceed that limit. If a Cool Limit was set in the Installer

Options, the cooling set point cannot be less than that limit.

Entering Your Program–7 DAY, Residential Mode

The 7 Day mode has separate Whole Week or Individual Day programming to allow you to change the daily set

point times and temperatures to meet your individual schedule needs. The Whole Week programming can be used

to set the main portion of your schedule, allowing you to later modify speciﬁc days of the week as required using

the Individual Day programming capabilities.

Whole Week –

allows you to program all seven days (M, TU, W, TH, F, SA, SU will show in display) at the same time.

Then you can use the individual day programming to ﬁne tune your program for the few set point times or

temperatures that you may wish to change.

NOTE: If Auto Changeover is enabled in the installer options, the heating and cooling programs share time and

fan settings. If a setting is made in either heating or cooling which violates the dead band, the opposite mode will

adjust up or down automatically to maintain the dead band spacing (see section 3.2).

1 2 3 4 5 6 7 8 9 10 11 ... 14 15

Comments to this Manuals

No comments

Braeburn 5400 User Manual Page 6

Comments to this Manuals

Related products and manuals for Thermostats Braeburn 5400